FRP / Fiberglass Pool
A single-moulded FRP shell — seamless, 8 mm thick, gel-coat finished and carried on an FRP-coated steel frame. No joints, no tiling, and a five-year warranty against leakage.
Engineered as one piece. Built to outlast the ordinary.
A single-moulded FRP shell is seamless from edge to edge — no joints, no weak points, no room for a leak to start. Behind it sits an MS frame fully coated in FRP: engineering meant for the long run, not just for the day the pool is installed.
Why it holds up
- Seamless by design — one mould means no seams to crack and no joints to fail over time
- 8 mm shell — engineered thickness that holds its structural integrity under water load, year after year
- UV-stabilised gel coat — the finish stays smooth and colour-true, even under direct sun
- FRP-coated MS frame — the strength of steel, protected from corrosion by a complete FRP layer
What that means on site
The shell arrives finished, so there is no RCC casting, no waterproofing trade and no tiling to programme. The work on your site is excavation, levelling, setting the shell and connecting the plant — which is why a fibreglass pool is quicker to build, and on most sites cheaper, than concrete.
Living with it
Gel coat is smooth and non-porous, so there is little for algae to hold on to and nothing abrasive underfoot. Routine cleaning is lighter than on a tiled interior, and there is no grout line to discolour as the years pass.
More swimming pool solutions
Interested in this
solution?
Tell us about your requirement. Our engineering team responds within 24 hours with a preliminary assessment and quotation.